bogges in low but not in powerband

[baycityryda]

i recently rebuilt the top on my 01 blaster it was bored .50 i went to .70 now its bogging in low mid kinda but comes to life in the powerband,i've looked for air leeks cant find any, i've changed the pilot jet from a 32.5 to 40 changes the main jet 10 times atleast. i'm a rookie at working on sh*t i'm just lost.help please

 

[hvpunk62]

you sure its just not your powerband is stronger now caz ik on my yz80 im rebuliding powerband will snap your neck on that thing along with a banshee id say its normal man post some vids

 

[4cfed]

depend on the bog, but a bog is usually rich, whats it do if you start at a low rpm and pin it wide open right away???? if you can post avid most of us can tell what needs to be done just by hearing a quad run and ride

 

[chriscblaster]

adjust your air screw.. make sure its 1 and 1/2 turns out firstly then start it up rev it up and down while adjusting the screw. when the bogging stops you leave the screw there.

 

[Blaner]

maybe check your midrange by adjusting your needle clip. check out Yellow Dog Racing - Technical Info For Your Ride for help, very straight forward instructions and troubleshooting

 

[baycityryda]

it only bogs when i ride not at idle,i'm changing my reeds this weekend see if that make a diffrence,but i did mix it kinda rich just to break it in i havnt even went threw a tank of gas yet so i'll go back to my normal mix

 

[chriscblaster]

trust me try the air screw!!

 

[hvpunk62]

video man! seriously your getting all these answers no one no's wht the problem is till we see it in action
thanks

 

[Jay]

just finish braking it in then post the vid.

 

[baycityryda]

i got home from work today and messed with it i took the air box cover off and rode it for a couple min. and she came to life but still bogged a little not much i got to 5 gear and could hardly tell,the thing that really sucks is i dont know a whole lot about working on motors my uncle always worked on my stuff and he moved out of state and i dont want to pay $70 per hour.thats why i'm glad i found this site.i'm still goimg to change the reeds this weekend when we rebuilt it i noticed one of the reeds wasnt shutting all the way and i know i should have changed them than but i was in a hurry.X(