blaster wont start

[blasterfreak]

Hi guys my blaster wont start .I was riding the other day and i went through water (there is a small hole about 5 mm big in the exhaust) and i kept on riding and then about 300m on i had a masive loss in power and this happened about three times.After the third time the quad backfired and didnt start since ,could it be a electrical prob or the carb or what plz help!!

 

[Blaner]

you probably got water in somewhere, where is the hole in the exhaust? it would be a good idea to clean the carb anyway so start there and perhaps whip that pipe off and check it out, take the spark plug off, give it a kick and see if any water comes out. you can check all your electrical plugs etc while you at it too, take them loose and spray with wd40 or the like!

Welcome!

 

[Prime]

You may have hydrolocked the motor.

 

[Surfrjag]

How far away from the motor is the hole in the exhaust? This could bring in air and technically be an airleak causing lean condition. Do compression check after what's stated above.... and fix that exhaust

 

[blasterfreak]

Ok i fixed the exhaust and cleaned the carb . I found that i have no spark ,can it be the cdi, and what is hidrolocked.

 

[Larry's Shee]

Hydrolock is when enough fluid enters combustion chamber and cannot be squeezed and stops the engine. Usually damage occurs. X(
Start by checking all electrical from the stator out. Clean connections,add di-electric grease. Clean and grease all grounds. Check back with what you find. I:I

 

[blasterfreak]

I found the prop my comtrol unit isnt woking so im going 2 repace it and c if it starts