blaster not running right

[Jaken84]

Just a update, both crank seals were leaking so I replace them, leak down tested again, put a 240 main in, pre mix 32:1, "I removed oil injection" plug chopped looked great, runs great thanks for the advice

 

[jarabe1]

Idle adjusting.

Start with air screw 1.5 turns out.

Set idle screw so that it has some sort of idle.

Warm up motor and then set idle screw for a fast idle.

Adjust air screw either way to get the fastest idle.

Adjust air screw a little at a time leaving 10 secs to allow the motor to respond.

Re adjust idle screw for desired idle .

can you please elaborate this? when you say fast idle do you mean highest RPM?

 

[Blaaster]

Thanks for your question, I must change that statement toread faster than normal idle.

Idle speed is 1550rpm, wick it up to 2000+, the idea is to get more air flowing under the slide.