blaster 4mm stroker timing question

[jus_me]

Correct me if I am wrong, you have a 4 mil stroker with a 1mil plate and a shaved head??? How thick are the gaskets you are using?

 

[Herpderplol]

130 psi is fine, 120 is fine.

Anything lower than 100 probably needs a rebuild.

The higher the psi, the higher octane fuel you must run. It doesnt have a lot to do with performance when you can just run reg gas

 

[DUALSTROKE]

Whats the squish?

 

[jreds4mill]

well the gaskets i used r .020" thick so x2 (one on top and one on bottom of plate) plus the 1.0mm plate and the head is shaved .010 and i used a stock head gasket (.032) so i could see what i could get away with wasnt sure if it was gonna b alot of compression or not.

 

[jreds4mill]

i was gonna put my thin headgasket it on it but i wanted to see wuth the compression was gonna b with the stocker