+4 swinger ???

[j carey]

how hard would it be to install a + 4 BANSHEE swinger on a BLASTER,has someone done this before?can someone walk me through it !!!
thanks

 

[Unstock240]

I don't know if it's even possible. The shock mount isn't offset like the blaster. The tube the bolt goes through would have to be cut for the motor mount, if it it even the same size. You could possibly get it to, just with more fab work than necessary.

 

[daniel3877]

I dont think its possible either...well..anything is possible, but it would take so much fabrication that it would be ridiculous. much easier to spend the $200 at the swingarm shop , bolt on and be done with it.

 

[j carey]

thanks guys,i just have a new one sitting around and though it might be a simple mod,looks like i will buy one then, thanks again

I dont think its possible either...well..anything is possible, but it would take so much fabrication that it would be ridiculous. much easier to spend the $200 at the swingarm shop , bolt on and be done with it.

 

[244blackblastard]

just extend the one you have to 4 inches. take a measurement from inside farthest point of swinger to center of shock mount. write down measurement. then cut swinger add in 4 inches of correct tubing size. then remeasure to find original shock mount placement and add in a piece of tubing across swinger centered on shock mount location add your tabs for shock mount which would be 1.5 inch X 1.5 inch x 1/4 inch angle iron with a 7/16 hole through each one. then your done a +4 swinger that looks stock.