350 banshee cylinder?

Boring out your cylinder gives very very little power increase. you wont even notice it.
You can buy a 240cc cylinder but a ported stock cylinder will wipe the floor with 240's all day.
 
Just stick around and read stuff for a while before you start throwin out all kinds of questions. lol everything you need to know about a blaster is here
 
Just like Scot said read around youll find helpful answers. It is not a great idea to bore cylinder like that besides youll will have barely noticable power gainage. I say ride the Bores all out... Or go with a 240.
 
Besides running half of a banshee will make you slower haha
They are only 175cc's per side. My shee on it's next to last bore is 185cc's per cylinder.
 
Blaner said:
what about swapping a whole banshee motor into a blaster frame? why have i never seen that been done?
Click to expand...

It's been done. Somewhere in the archives I have pics of such a swap.
I guess the only drawback to a swap like that is the cost and time.
It would be cheaper to just buy a shee.
 
It was a green drag blaster with a shee motor which isn't a bad idea if you have the skills to make the mounts.
 
You must log in or register to reply here.

Similar threads

mmmorphine
Looking for engine
Replies
0
Views
98
Wanted
mmmorphine
mmmorphine
F
Banshee front shocks on blaster
Replies
1
Views
335
Shocks
FLBoy86
F
C
Are my cases still good?
Replies
0
Views
119
Engine
Chaotic
C
Nathanh10
Exaust flange problems
Replies
0
Views
208
Exhaust
Nathanh10
Nathanh10
AlexTF
why is smoke coming from the front of my engine from where the cylinder connects to the bottom end?
Replies
0
Views
264
Engine
AlexTF
AlexTF
Top Bottom
Back