2004 blaster build

[Racer51]

Hey guys as very few of you may or may not know my blaster is dead. So I'd like some opinions /options I can go with for pistons and cranks. and a cylinder being bored out to .050 or 67.25mm over. I need quality parts just like any one else. Here are links to parts I need but would appreciate opinions on them weather or not there good to use/are they good and fair prices you know the usual. I talked to a very repubatle person that has been doing bore, hone, chamferings for 40 years and quoted me for$70-80 to get it done to match the pistion I'm gonna need. But if you know off the top of your heads Ken O'connor will do it for less that that shipped let me know and I'll weigh my options.Thanks a ton I've been on here a good while and will take all your guy's advice seriously thanks a bunch again.
Yamaha Blaster Wiseco .050 (67.25)mm Piston Kit YFS200 | eBay
Yamaha Blaster Wiseco .050 (67.25)mm Piston Kit YFS200 | eBay
Eather or piston kit on the first 2 listings OK.
YAMAHA 200 BLASTER WISECO CRANKSHAFT CRANK BEARING GASKET KIT 1988-06 | eBay

 

[JonS]

70-80 is redonkulous man. i'd go with Ken any day of the week. also, rjatv is good place to buy piston kits. get just the piton though and then OEM base gasket and head gasket.


the local speed shop here charges 40 bux though.

 

[Larry's Shee]

Just had the Banshee bored, 48 a hoe, YAMAHA YFS200 BLASTER 3MM STROKER CRANK PISTON GASKETS | eBay, I've known Mike for 12 years or more. Check his EB store might have other kits as well. I got simular kit for banshee, beat him up on price because I'm local so he saved shipping. Good turn around too. Shipping wouldn't be too bad as he's only about 4 hours north of you, lol.

 

[Racer51]

48 a hoe??? I'd seen it trooling e-bay I'm probably going to since I have to get the crank out now...But what I'm gonna have to do based on my money situation is go with a bore and get the piston kit. So i'm 2/3rds the way done .(It'll make me feel like I got more done than I do.)Since I'm gonna do my second low end myself since no one in my area is that trustable. I saw ken's prices and there good on doing a low end but by the time i count in shipping charges back and forth it'd be about the same if not a good bit more when all said and done so i dont know yet.