Recent content by roger489

im going need a crankshaft also. if anyone has a good one laying around. i took it apart today and its missing one thrust washer and the rod is burnt black on big end.

i want one pm sent

Im interested, Pm sent

Here's a short video of the race ported trailblazer. I had just put clutch, pipe and carb. And was just working on jetting.

Thanks Sonia! Pm sent to 1995

This weekend I picked up a 92 blaster for a $150 and it runs. But needs some parts. I need a rear fender(white if possible), front lower brake cable, rear brake cable, brake and clutch levers, an if possible I need both clutch push rods and bearing ball. I need gaskets if anyone has some just...

There's 3 places I ride locally and range from 2000-10,000 acres. St. Joe, washita, and mark twain nat'l forest area in Womack(my sisters property backs up to it)

anytime anyone from here goes to St. Joe give me a shout, i live about a mile from there.

you would ave to pull all bearings, ball joints(if removable), grease fittings, chain guides. most likely sand blast them to bare metal. as far as a arms if they are stock with non removable balljoints, i wouldnt do them. you would be looking for new ones soon after. the 300-400 degree wash/salt...

Do you still have the tusk gas cap? If so what's price shipped to 63601 thanks

It took be about 2yrs to get the s10 that way. The amc will take longer once I get started on it. I seriously thought about just fixing it up to drive daily. Its a '69 and rated to get 30mpg with the inline 6 that's in it. But the blaster is way faster than it is. Lol

The rambler will get a amc 390, if I can find one. If not be a 401. And will be done as a hurst sc clone. But sheet metal for these are rare and expensive. Im really just in gather and store parts for it now. It needs a dd side rear quarter and roof skin. It's been rolled lol

Believe it or not, there's only about a quart of filler in it. All metal, a lot of welding and hammering. The rambler is gonna have a few gallons though, as good panels are next to impossible to find lol. and yes the engine is for the truck. It's a 415 cu in sbc, AFR heads, crane solid roller...

Already build ready to go in. Just not enough time lol and will be taking donations for gas to feed it. Lol And yet my next project is waiting already That's not including the atv's, dirt bikes, and other stuff

One of my many projects i got going. It's still a work in progress though. I don't get to work on it much. Right now it's a dust collecting shelf in the garage lol