Recent content by nathan bickom

you have a lower end or a good set of cases

looking for engine cases or compleate lower end

any engine cases?

BAR RISERS

ANY ONE KNOW A PART NUMBER OF A LONGER THROTTLE CABLE TO FIT A BIKE WITH THE TORS DELETED?

looking for a 2003-2006 right side foot peg. has tp be 2003-2006

thanks, im starting to thing water is getting in to the plug i disconnected for the parking brake switch. i am going to cut it off and cap the wires and see what happens. thanks for your reply

i have a problem with my sons 2006 blaster. when in wet conditions it will act like the rev limiter is at 2000rpm and you wont be able to give it throttle. if i wiggle the harness in front of the quad going to cdi it will start to run fine again. sometimes it wont happen for months, this weekend...

Found this online '04-'05 YFZ450 = 12.375" RAPTOR 125 & 250 = 9.75" RAPTOR 660 = 12.375" BLASTER = 9.25" BANSHEE = 10.875" Are the tie rod ends all the same? Looks like I could use raptor or Yzf450 ones as long as they are 10mm and same tie rods

I could but they were a lot more expensive. Yzf450 ones can be had for under 20 dollars on the bay

installed a diamond j 6" kit on my sons blaster. dont really like the tie rod extension. can i use yfz450 or raptor tie rods in place of? if so what years. thanks for any help

Looking for extended a arms for a 05 blaster +2(or +3), +1. Let me know what you have

Ya it's a big range but where we live is sea level and our camp in tug hill gets up close to 3000. So usually jet for around the house and live with it at camp. Thanks for the info.

I got my son a blaster for Xmas. So I g some work on it befor I give it to him. I added a k+n filter, removed the air box lid, Boyesen reeds, and a toomey muffler with stock pipe, removed tors and did an oil injection delete. Where would be a good starting point for jetting. It had a 230...