Recent content by little blaster

Hello I need the clutch cable bracket holder that goes on the base of the cylinder I also need a clutch cable adjuster, if you have one lmk thanks

I have a tors delete with a cap already thanks for looking out I appreciate it

Ok how do we trade I haven't traded on forums before

As long as it has the slide, needle and spring, of course

98blaster I would love to trade you, I'd rather just trade it off it's not worth my time to jet it

Stock porting, fmf full exhaust and uni air filter

Hello I have a pwk 28mm carb that I got in a trade and I can't seem to get the jetting even close, if I could get help that would be nice or maybe of someone has a good stock carb I might trade them, I can't seem to get jetting down thanks for any advice in advance

Thanks for the help it's much appreciated

Hello I was riding my blaster the other day and I thought I blew it up, I was tearing apart the intake to inspect the wreckage and found out it had a large chunk of the reeds missing and I'm gonna put new reeds can I run it or should I tear it down and look for the reed pieces?btw thanks For...

Ok thank you the help is much appreciated

Hello I rebuilt my blaster top and bottom end a year and a half ago and put a good 300 hours on it and have been very satisfied with it, but my wiseco piston decided to go south, I'm very satisfied with how long it lasted but I have one question when I rebuilt it, I had ken redo the crank for me...

I'm an hour from Vegas a town called pahrump

I'm an hour from Vegas a town called pahrump

I can do that when I got home from school

I don't think exhaust is leaking have a good worm gear clamp on carb i have replaced tranny side seal 2 times with same results watching ken oconnnors videos no mods all stock and stock jetting pipe is pefect even switched with good running blaster and passes leak down test with flying colors