Recent content by germanblaster

Hi, i have a problem with my 03 blaster. I bought an fmf powercore exhaust and installed it on my blaster. My Carb is stock, airbox lid is not removed and my blaster has an K&n airfilter. I ordered jets in the range of 240 to 310. First i tested a 290 jet. The blaster has accelerated...

my budget is to low to buy some new reeds /: but the 4° timing is possible are there any descriptions of this modification available? i think buying some jets from 260-to 300 will reach to get the carb setted ?!?

thx and what jets i have to order for k&n +fmf ?

Hi today my blaster got street legal and i will receive my fmf fatty exhaust system soon. In this case i have to order some bigger mainjets for the stock mikuni carburetor. My setup is: -everything stock: bore, reeds, carb etc - K&N Airfilter -I have a stock airbox lid and one with some...

hi does anyone know, whether wheelhubs from a raptor 700! not 660 would fit on a blaster axle? thx

i think i have to go and measure the brake und sprocket hubs ?! when the sprocket hub is shorter than the brake hub , rotating will make it equal wide?! Does anyone know whether the carrier ends are identic off center? I remember that one end of the carrier is a bit off center?!?! on this...

yes both valve stems are on the outside do you think rotating the axle would help or would that be wasted time=?

i measured from the footbars from the plastics and some other ponts when im standing in front or behind the blaster i can notice that one rear is wider without measuring are the two points where the carrier attached to the swingarm in center? here are som pics but on the pics it seems to be...

It fits in very well only the right side/ the right wheel is about 0.5-1cm wider than the left side )=

hi again today i put the axle in the swingarm after waitung for this f+++++ axle nut (m33 p1.0, no screw shop had this nut size )= the install was very easy but i noticed that the right side is longer than the left now i´m very pissed of this axle, that makes the reartyres unsymetric )=...

My First Blaster from 1996 very great condition as i bought in 2010 then in winter 2010 some assholes destroyed this pretty blaster i got the money back from insurance and bought this blasty of 2005 with fmf fatty and k&n airfilter I sold this Blaster a few weeks ago and bought...

XTREME Racing Hinterachse + 10cm für Yamaha + SMC/Barossa - Löffler-Quads I just ordered this axle and hope for trouble-free install. I will forward some pics of the install and the result.

ok thx back to the axle atm there is a used mx force axle in ebay for 180€ out of a raptor 660 do you thing i should prefer the mx force axle ?

A motocycle crashed into the rear of the blaster, only the axle is bent frame and swingarm are ok right The spacers/hubs? with 45mm on each side will arrive soon. The Problem with the Valves then still exists??