Recent content by dczys

Installed 175 main and 55 pilot and still had some bog at the end of first 3 gears. Had no lid on airbus so I covered airbox about 75% and that did the trick. She's running perfect now! Thanks.. now who wants to buy thus thing?

What is the process to make the needle adjustment on this carb? Thanks!

put in the 165 main and 55 pilot, and it still cuts out, but not nearly as bad as it did. at the end of 1-3 gears it just bogs.. Need to go with some bigger jets im thinking 170 or 175 main.. and im not sure about the pilot jet maybe another increase?

carb*** sorry typo

Pulled carbon again and was running 150 and 48 getting. Ordered 160, 165 mains and 50,55 pilots. Hopefully that will do the trick.

awesome thanks!

have a CPW30 OKO carb and need to get some new jets, looks like Keihin jets are what i need, the 6mm hex jet.. just want to make sure. please let me know. thanks!

What oil gas ratio should i be using? Currently i have 32:1 in there.. Should i be up more to like 40:1 or higher with these mods?

How to plug chop?

I just pulled of the plastics and removed the aluminum air box / and tubing to the carb. Then pulled the carb and took off the bowl and pulled the main jet. Now that i put it back together i cant remember what that jet size was. I am thinking it was 120 but i am not positive. I then put the carb...

I did a search but couldn't find a good answer, for my situation. Blaster will cut out at the end of the first 4 gears at full throttle. Will run fine though up until mid-top end of those gears then bog down. once i get into the last two gears it will rip through all the way and run fine without...

yea it sure would have been.. nice to know from the get go... o well how it goes sometimes..

put on new head gasket, and the problem remained.. dug in a lil deeper and what do i find? missing nut on base cylinder , and blown gasket.. so mystery has been solved....

got the new head gasket today, and i will tear into it in a next weekend and let you know how it goes.. thanks!

cool thanks mike!!!! i'll yank the head and clean it out then, and look around. recommendations on what to use when doing this, and also should i get another gasket and replace the old one? the old one isnt too old. and also what ratio would you recommend i run? i got bigger carb, aftermarket...