Recent content by bob87

Thanks for the advise people i will do this on monday and let yous know what happens

Thanks. Do you think i would be able to flip them or should i just wait to try get new ones shipped

Yes quad run before then i blew the piston. Got a rebore and new piston. Leak test and good compression. Just wont start now.

Yes quad run before then i blew the piston. Got a rebore and new piston. Leak test and good compression. Just wont start now.

another pic

here are pics, do you think I could flip them around?

How do i upload off iphone? Yeah the reed stops i dont have. No chips or cracks. They are white transparent ones. There is about 2 mm gap in the reeds both sides

Thanks for the replies. No i just have a small gap in the thin plastic flaps and the body. But for some reason i dont have them thick plastic pieces. Are they needed? If a small gap wouldnt make a difference what else could be wrong

Can anyone tell me what the reeds are meant to look like? Mine has a small gap between the flaps and the body. I cant up load any pics

Thanks awk. That would stop it from starting too wouldnt it? And where could i get a standard one from as i live in ireland

Hi i just rebuilt my engine but bike wont start now. I only getting a small spark and is it normal for air to be blowing back up intake when kicking it?

I May rebuild top end anyway cos very little compression i can move kicker down by hand

only had a quick look at it before i left it. doesnt look to be any holes in case and it will turn over by the kicker by hand. altough it does sound rough when doing this so the engine isnt seized. i will hopefully take it out during the week and get pics for yous as soon as i can

hi was out riding today and my back wheels locked up and engine died.. got it into neutral and towed it home. i tried to start on the run while being towed but the wheels just locked up again. it will kick over but no great commpression. i know i may rebuild top end but does anyone think i have...

that last post is no good so haha yeah it was a bad design that you cant change the ball joints seperate