Recent content by blaster 06

Tanks for the help.I ended up taking off the exhaust and the carb and spark plug and kicked it a load of times and turned the quad upside down.There was a lot of unburnt petrol lying in the engine so when i was starting it before the petrol in the cylinder was dying out the spark in the...

the petcock is fine because when i take the pipe of the carb and switch it to on petrol flows out?thanks

i have an 06 blaster and it was going fine for a long time but it ran out of petrol one day and it hasnt started sinc and when i do get it started when i go to rev it it konks out i took the plug out and cleaned the carb and it is still the same can someone please help?thanks

Rite lads its alright i pulled the cover off.The nut was loose but the nut had blue loctite on it already so i dont know how it came loose.the ball hasnt wwelded itself to the rod.Was lucky tanks lads

rite lads im after putting new selectors in my yamaha blaster and it was going 100 percent until i drove it for a while.I was in 4th gear and i went to go down the gears and it wouldnt go down the gears.I had to stop and it wont go into gear at all.When i pull the clutch it feels like theres no...

the oil level is good i have no manual the shaft isnt bent but i never checked the shaft adjustment ill take the cover off and check it thanks lads for te help I:I

thanks for all your replies its workn good now but it wont go past 3rd gear but its not slipping in the first 3 gears ???????????/

could someone tell me how tight to tighten the clutch springs on my blaster but i hav no torque wrench please???????????????????????

rite and how tight should the springs be i dont have a torque wrench and should the lever line up with the marking on the case when the clutch is off??????????thanks

i have the plate aligned right but im not 100 perceny sure how to adjust it i tighten the screw until it pushes the lever and then tighten it i was talking to someone and they said if you put another steel disc in beside another one it will fix it???? is their any good threads on how to adjust...

ok i got that problem sorted out but now when i drive it and rev it high it just revs out????? i put normal 75/90 in it would that be the problem????thanks

well i have an o6 blaster and i am after changing the clutch in it i have it all back together now and when i try to kickstart it the kick starter doesnt even go down could the spring for the kickstarter be out of its slot?????? i have a race on tis evening nd i need help ASAP thanks very much