Recent content by Alf
-
A
how do a person screw the head and top studs out?
Tx all, will do the nut thing. -
A
loosen head and top studs?
How do you loosen the top and head studs (bolts) ?-sorry, i post this question twice, ignore please -
A
how do a person screw the head and top studs out?
I want to srew the old head studs out but can not it to unscrew, any advise how? -
A
sandblast head and head cylinder
Hi,will there be any negative impact on the cooling of the engin if the head and head cylinder is sand blaster and not painted again,left as it is?tx -
A
How do you measure 4 deg timing
It can be measured with a protractor, or a timing disk. I did use a protractor and I know it is not the right way because the markings were about 2 deg on the protractor. I was just curious about it would like to have it as accurate as possible. Tx all -
A
How do you measure 4 deg timing
Hi all, I have slot the holes with 3 mm on the stator but the markings apart is not 4 deg if measured, so how do you know it is 4 deg, can it be measured? Tx -
A
advanced timing question?
Hi, How does a person know if it is +3 deg or +4 deg? how do you measure it, I made markings for the stock setting but how from there? Tx -
A
Removing Universial joints on front suspension
the manual talks about universial joints so i used the term to prevent confusion on the forum. tx though, i have tried to wack it a few times but no luck, i damaged the tread on one ball joint. will be patiant on this job. tx for advice.- Alf
- Post #8
- Forum: Suspension
-
A
Removing Universial joints on front suspension
Hi all, How can I remove the universial joints or do I need to get it pressed out? I even struggle to het them of the steering stem. tx- Alf
- Thread
- Replies: 12
- Forum: Suspension