Recent content by 1998blaster

  1. 1998blaster

    help need...?? what screw is the idel screw on a 300ex..??

    i just got a 2000 300ex the other day and it won't idel.. what screw is the idel screw..???
  2. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    is a 03+ blaster carrier and an 03+ warrior carrier the same..???
  3. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    i sold the warrior motor today...but i still have everything else...is there any bearing's on the axel where the rear brake disk is..??? i noticed mine is alittle sloppy ..could the clips be bad..?? or what is it???
  4. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    i tried it today and it will i just need to make the brakets..
  5. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    i don'tknow.. but... im gonna see if the rear hydro's will fit...????
  6. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    well i have front a-arms and a rear end and a motor that i can't use.i don't know anything about any of it.. how much is all of this worth..???
  7. 1998blaster

    will front disk brakes off a 350 warrior fit a blaster..??

    i got some parts that i believe are for a 350 warrior.rear end,motor and front a-arms and front disk brakes... i was wondering if the front disk brakes would fit my blaster or not..??? what parts will interchange with the blaster and warrior..???
  8. 1998blaster

    cutting reed stops off

    well i was gonna take them off and put them in a vise and cut them right at base where the screws are and file the edges down good and put them back on so the screws and the base will still be on the reed. .
  9. 1998blaster

    cutting reed stops off

    i was thinking they worked more like a govenor or a restricker plate..so are you saying that it will work great on take off and low end..but... at top speed it will shut down..???
  10. 1998blaster

    cutting reed stops off

    loss..?? how..???
  11. 1998blaster

    cutting reed stops off

    i've heard of some people cutting off the reed stops on there reeds.does this really work...??? how much would i gain on a stock motor with just a aftermarket pipe and k&n filter..????
  12. 1998blaster

    wheel spacers

    whats the best size to use..?? 4 or 5 inch???
  13. 1998blaster

    Haspin Acres

    i've only been once but i went during the week and there was like no one there lol..i took my sand rail and blaster and had alot of fun..i bet there are alot of people there on the weekends though.
  14. 1998blaster

    Oil leak!!

    mine used to leak a bit too.look underneath the right side of the motor..look close and you will see a really small sqare hole where the outer case meets the inter one..thats where mine was leaking at..i just siloconed mine and it seemed to work ok..
  15. 1998blaster

    custom skid plates

    i made my skid plates this same way..it's a hole lot cheaper..i don't know if it was the best way or not ... but i just used small self taping srews..i just bought a 2x2 sheet for 15 bucks and it worked great..
See more
Top Bottom
Back