Media

blaster3

blaster3

  • 0
  • 0
blaster1

blaster1

  • 0
  • 0
bblaster2

bblaster2

  • 0
  • 0
IMAG0089

IMAG0089

  • 0
  • 0
IMAG0090

IMAG0090

  • 0
  • 0
IMAG0091

IMAG0091

  • 0
  • 0
IMAG0093

IMAG0093

  • 0
  • 0
IMAG0094

IMAG0094

  • 0
  • 0
IMAG0092

IMAG0092

  • 0
  • 0
rear rack holds small igloo cooler and 1 gal gas

rear rack holds small igloo cooler and 1 gal gas

  • 0
  • 0
I was told custom case saver?

I was told custom case saver?

  • 0
  • 0
"red whit and blue" funny thing is the seat and springs are orange!!?!?!?

"red whit and blue" funny thing is the seat and springs are orange!!?!?!?

  • 0
  • 0
KLOTZ OIL

KLOTZ OIL

  • 0
  • 0
cfm box mounts

cfm box mounts

  • 0
  • 1
Cylinderporting007

Cylinderporting007

  • 0
  • 0
KOR modified head

KOR modified head

  • 1
  • 0
179612 149881121737266 100001461376407 294495 2743357 n

179612 149881121737266 100001461376407 294495 2743357 n

  • 0
  • 0
fun fun fun

fun fun fun

  • 0
  • 0
imagesCACBAX6V

imagesCACBAX6V

  • 0
  • 0
so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!

so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!

  • 0
  • 1
heres a profile shot demonstrating how much deeper these cr reeds are!!

heres a profile shot demonstrating how much deeper these cr reeds are!!

  • 0
  • 0
it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.

it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.

  • 0
  • 0
they sure look good in there

they sure look good in there

  • 0
  • 0
i shave around 1-1.5mm off each side with a flat file and sand paper tape

i shave around 1-1.5mm off each side with a flat file and sand paper tape

  • 0
  • 0
Top Bottom
Back