WTB bottom end

slickerthanyou

slickerthanyou

New Member
Dec 23, 2009
7,615
140
0
Just got ripped off from a guy on craigslist. paid $100 shipped but when it came it was trashed, wasn't the same motor in pics. The clutch springs blew and ate the inside gears and case to hell also has Jb weld everywhere. X(

So now lookin for another hopefully with flywhee/stator, can't pay more than $100cash shipped as that's all I have. If your into tradin I have a set of aluminum nerfs that will need new netting, and a torn apart bottom everything but flywheel/stator. lets deal, can get picks of anything PM me.

Thanks- Bob
 
i might have the gears you need...i just got a parts motor cause i needed the cases, hopefully next weekend ill swap the case halves, after i verify that i dont need the transmission gears, theyre available for a good price.
 
I actually have two bottom ends one from the original and this piece of crap. The one i bought has the clutch blown apart- blew out the side cover stripped the gears and there is a hole in the bottom of the case about size of a half dollar if you pick- I'm sure the inside is probably trashed. I am going to attempt to reassemble the original and use the flywheel/stator from this sh*tty one, I planning on sending out the motor out for a rebuild as I just don't have the time to do it. I wanted to get it p&p and matched to the +4 crank, but after seeing a pic of the case trenching and how thin that one bolt hole is I think I may just go with stock crank.

I was hoping to get a good bottom end and use the original bottom end for spare parts. Oh well nothing ever goes as planned.
 
that sucks man.... i wanna get just the left side case the flywheel side..... but besides that good luck and get a +3 crank instead a lot easier then the +4 and no trenching
 
You must log in or register to reply here.
Top Bottom
Back