throttle broke ??

[Drifz1]

hey guys i was putting my slider back in as i put it in the rong way once i had it in i pulled the throttle and i heard a snap and the throttle did nothing anymore! so i took it out and the needle a lil bent nothing major!but when i pull on side of the cable/slider nothing happens with the other so im guessing its just snapped until i both pushed them in together ! and the pulled on side and the other went aswell(it worked for a sec )but now nothing so where do i go from now???

 

[Drifz1]

and when i push the bit in that comes from the thumb trottle i can hear something catching ?and i you start playing around pushing one end in etc it will work again for a few sec any help?

 

[Whitty21]

is the slider running up and the guide screw?

 

[bagds101]

try this... if you have one problem, post it all on one thread. just kidding man. but take off the throttle cover and check that. or take the throttle cable out of the slide and pull on one end to see if it stays together or comes out

 

[1995blaster]

ya check out the cable under the throttle cover and i had mine come unhooked under the tors box the last time i took my carb off
to check the tors box just take out like 5? screws and the sid should come off and there u go see if its hooked up good

 

[Drifz1]

ya check out the cable under the throttle cover and i had mine come unhooked under the tors box the last time i took my carb off
to check the tors box just take out like 5? screws and the sid should come off and there u go see if its hooked up good

ya i did it before i read this and thats all i thanks anyways guys!