ok so i had to pull my flywheel of and i had to use a spacer for the puller i use and i use a large nut and use a corner but it stated slipping so it smashed 3 threads down how can i get the bolt on with a trick with the rethreading tools.
threads smashed
- Thread starter liljatownboy
- Start date
Yes, use your nut to find the correct dye(rethreader) size. Clean the threads up on the end enough to get ur nut past them.
Make sure to put a mark on the end of the threads where the key aligns b/c when you put the flywheel back on, its hard to tell if you're lined up or not. (I used a Sharpie) When you think you got it lined up, bump the flywheel lightly with a rubber hammer to help it get started to seat on the crank.
Make sure to put a mark on the end of the threads where the key aligns b/c when you put the flywheel back on, its hard to tell if you're lined up or not. (I used a Sharpie) When you think you got it lined up, bump the flywheel lightly with a rubber hammer to help it get started to seat on the crank.
yea i know oh boy is right!!! well i can get the flywheel on fine thats no problem i just need to get a nut on it.
Similar threads
