So I am about to have my buddies welding teacher extend my swingarm and need to know how hard is it to take apart my swingarm and will I need anything special to do this planning on tearing it down in a few days.
Swingarm/axle teardown?
- Thread starter cruelsoul
- Start date
nuthin special, undo the brakes and chain, pull the large swinger nut that runs thru the rear motor and frame, and heres where some pb blaster and a BFH may be needed,
do not fug up the threads, use an oak block to beat on, not directly on the end of the bolt
then holler if that doesnt work, i'll come help ya !!!!!
do not fug up the threads, use an oak block to beat on, not directly on the end of the bolt
then holler if that doesnt work, i'll come help ya !!!!!
Similar threads
