sticking master cylinder

[jfblasterboy65]

when i got my shee rear brake set up there was a lot of crap in the master cylinder, line and caliper... well i cleaned them all out with brake fluid and such and put it all back together and bolted mt master cylinder onto my 05 brake pedal and hooked the rest up with a bracket i got off awk for the master, when now my problem is when i push down the pedal it gets stuck and will not return all the way up if at all even when i push a lil bit.............................BUt when i had it off and pushed the piston thing up in the master cylinder it returned back out which would make the pedal return but for some reason it wont when i hook it to the pedal, any suggestions????

 

[Awk08]

you prolly dont have the rod/piston aligned exactly straight, it has to go into the master perfectly straight or it will hang, on the way in or the return trip
if you have to, i'll repair it for you, just send it in, even though i didnt do the whole set-up, i will help you out, holler bro
get me a pic of the master set-up?????

 

[jfblasterboy65]

aight awk thanx i was thinking it might of been the angle that it was on ill snap a pic in a lil bit when i go out there

 

[Awk08]

if the rod is going into the master at any angle except straight, you've got troubles, it has to go in straight

 

[jfblasterboy65]

aight well the way i have it bolted to my 05 pedal i had to suck up the one bolt a lil so its a lil tiny bit angled ill hve to check its just mad cold out right now went from high 60s to like low 40s