hey guys im new to this forum,i have had my blaster for about 7 years now done everything to it,it recently set around for about 2 years and i got it pulled in the shed and put freash fuel,plug basic tune up and i have no spark. i pulled the magneto off and there was a little moisture behind it (due to a chip in the block) i dryed it all off and put it all back together and still no fire,is there any way i can check the pulsar coil or wat not? any help would be great! i also have a vitos degree key ive had for sometime now but didnt have the puller to remove the magneto,got the puller and put the new keyway in,its to advance the timing 4 deg,im assuming to advance the timing the magneto will be moved forward but just want to make sure,thanks every one!!!
spark problem
- Thread starter ftlboy717
- Start date
http://www.blasterforum.com/general-support-17/downloadable-yamaha-blaster-manual-17325/
Download the manual an use a multimeter to check the stator coil.
Good spark needs excellent earths to be in the ignition curcuit.
The flywheel key will not stop spark happening, it only moves the flywheel to a different position on the crank shaft.
Is the TORS still connected, it may be the scource of your problems?
Download the manual an use a multimeter to check the stator coil.
Good spark needs excellent earths to be in the ignition curcuit.
The flywheel key will not stop spark happening, it only moves the flywheel to a different position on the crank shaft.
Is the TORS still connected, it may be the scource of your problems?
Similar threads
