The push lever is coming out of the engine case this is where the clutch cable connects to engine how the he'll do I fix that my new pistons are in mail on way and I wanna ride easy fix or not al much lemme know thanks ??
Push lever coming out??
- Thread starter blasterboy2000
- Start date
I took the head off my motor to do a rebuild and I noticed my clutch lever was loose so I followed it down to where it goes into the engine and the entire push lever with the spring on it that whole rod I can just pull up outta the engine it's not hooked to anything so now when I pull clutch on it doesn't snap back and clearly that wouldn't be air toght anymore
You won't get an air leak because it's sealed of from the crank case. I beleave the spring is what holds it in.
no worries about airtight, that goes into the tranny, which is vented
and the spring holds it down in, kinda, if you pull up on it, it's gonna come out, thats how it is
get the spring on it correctly ...hooked to the the arm, and hooked to the case
and the spring holds it down in, kinda, if you pull up on it, it's gonna come out, thats how it is
get the spring on it correctly ...hooked to the the arm, and hooked to the case
Last edited:
Also, the "paddle" end is "hooked" down by the clutch pushrod. Once the clutch is sprung down, the lever arm cannot come up. If the clutch isn't supposed to be loose (you haven't touched it) but the clutch actuator arm is still coming up out of the case, you need to release the tension on the pressure plate and let the pushrod tension up so the actuator arm can slip back down into place.
dont worry all you have to do is push it in tight and adjust the spring when you get it on there and your good to go
Similar threads
