Please explain this cr500 stud fix

ChrisZx7

New Member
May 15, 2012
794
4
0
Rochester, Ny
I do not see how using the cr500 head stud is possible. Due to its "step" how does it allow the head to sit flush onto the jug like the stock studs?
 
I have the cr500 stud sitting right here, and i wont drill this stud hole out to proper size without proof that it works. Pretty pissed off i have a ported polished and fresh bore top end thats useless.
 
you have to use a bigger bit and drill down the depth of that step to allow it to counter sink into the head.....from what i understand, Ken-O is the only person i know doing this "fix", a simple call to him in the morning after 9am. and i'm sure he'll be more than happy to set you straight on how to do it !!!
 
you have to use a bigger bit and drill down the depth of that step to allow it to counter sink into the head.....from what i understand, Ken-O is the only person i know doing this "fix", a simple call to him in the morning after 9am. and i'm sure he'll be more than happy to set you straight on how to do it !!!

That makes sense. Ill give him a call tomorrow.