I am going to be reassembling my motor at some point in the no too distant future after a rebuild and am going to have a KOR milled and reshaped head, KOR stage 1 porting along with a DMC full exhaust. I was planning to just go with the DMC recommended jetting (32.5 pilot, stock needle 5th position and 260 main), but as those are recomended for an otherwise stock moter, I am wondering if anyone else out there is running the same or very simular set up and what they are using jetting wise. Will be riding @ about 1000 ft above sea level usually about 60-85 degrees. Any insights as to weather the KOR mods will require a different base jetting set up?
