So i dont understand how this works..can some one please explain how the plates go in and how i turn them as i put them in and also how i set the tension bar
Installing my new clutch
- Thread starter UniRacing
- Start date
Thats helpful but i took my clutch off last night and on the metal plates there is a hump that comes off the side on each metal plate...does it matter which way they face?
or this will be easier,is there a specific way they slide in or they just go in randomly? (friction-metal-friction-metal and so on)
One moment ill get pictures,cause this is tricky,doesnt seem like they can go in at any way
Ok see this lump in the metal,all of them have these,do they face a certain way as im putting them in?
Also does the ring go back in with the new clutch(tusk)?
Last edited:
i dont think the lump matters.....and it should say in the instructions if you use that other ring or not
Thanks..when taking them out it didnt look like they were in specific ways,but i figured my clutch could have been f*cked up from that before,thanks.
i was thinkin about getting the tusk clutch kit of of ebay...how did it work? was it fairly easy to insatll once you got it figured out?
Similar threads
