I Really Need Help :(

[squeaklad]

i just came home from school today an was taking the blaster over the road to bring it up to a field, as i was pulling into the lane the chain poped off i thought nothing of it because it was loose from the time i got it. i stuck the chain back on and now i it wont go anywere. the chains are on the sprockets but when you put it into gear an do the usuall to get it moving the engine just revs. if you rev hard it will move maybe 5cm and thats it. i just finished washing it before i went out on it.

Help Me Please What should i do or what is the problem.



also i only bought the 01 blaster last friday and we have found out the whole frame of the bike is bent as it has being crashed. i didnt know this when i bought it. since i only bought it last week should i ring him back and try and get the money back. i payed £800 pounds for the bike which is about £1500 dolars to uns for a 01 bike. PLEASE help me

 

[ridinfast03]

Is the front sprocket ok, are the teeth rubbed down or gone completely

 

[squeaklad]

no the teeth are still there but its not turning them. i have waited a while now and it will move but not very much in anygear.

 

[darealblaster]

all you gotta do next time is Inspect before you Buy! lol good luck with the problem cant help

 

[CC&Fabb]

might want to check your clutch/pressure plate. Also check your flywheel and make sure everything is good witht that. If you engine is running strong then check that stuff first.

 

[squeaklad]

the engine seems to be running strong. it has to be somthing to do with the clutch. it would maybe do 20mph at the min but thats it. is it dear to replace the clutch or flywheel?

 

[89custom]

the inner part of the sprocket that holes onto the main drive shaft might be stripped. check to see if the sproket is attached well to the drive shaft. if the drive shaft isnt turning when in gear, you have a major tranny problem.

 

[tjsdaname]

the inner part of the sprocket that holes onto the main drive shaft might be stripped. check to see if the sproket is attached well to the drive shaft. if the drive shaft isnt turning when in gear, you have a major tranny problem.

good call

 

[squeaklad]

the sprocket is attached fine. how far should it turn when its in gear? once its out of gear should it just turn freely? i drained the oil out of it tonight so. i think what maybe has happened is that i didnt know how much oil to put in so i just poured it in and i think i put far to much in and bust a seel. whould that happen?