high idle blaster

[kelby21]

I recently rebuilt my blaster. It has a +3mm stroker, fmf fatty pipe, and k and N filter with removed air box lid. I have put a 310 main jet in it and it still idles high with the the air screw all the way in.
Question 1
Does the silver thumb screw on top of the carb still work if the TORS is removed?

Q#2

I noticed my reed has a small chip at the bottom. Would this cause a High Idle?

Q#3

The previous owner adjusted the innards of the thumb throttle. Could that be the problem?

Thanks for any advice

KR

 

[kelby21]

*BUMP*

^bump

TTT

 

[peacher213]

Hi, Ya the screw should still work, did you turn the air screw in until you could feel it sit, and turn it 1 1/2 turns out? This should get you close. Then check how tight your throttle cable is. If it is too tight it will idle high. It should have a Small amount of play. Now warm the bike up, THEN adjust the idle... let me know if it helps.

 

[2strokenitfast]

yea idle screw needs to be 1 1/2 turns out