had spark before rebuild

[2000blasternewb]

ok so my buddy got a blaster didnt run but had spark. so while i ordered some parts to rebuild the motor, he tore the bike down to the frame and repainted it. Now that the bike is put back together there is no spark. We took frame to baremetal to all the ground locations and the coil also. does the motor mounts have to have bare metal against them also? He didnt unplug any wires from the harness when he removed the assembly, only wires he unhooked were the four from the magneto coming off the bike. Any ideas on why it has no spark? If we cant figure this out were goin to cut everything off the bike except the cdi box and kill switch circuit.

Footnotes
Bebuilt bike
Had spark before doesnt have spark now
baremetal at ground locations
everything is switched on and tors is hooked up.

 

[Juggaloclownz187]

Not positive without you testing with a meter but...... Get rid of that damn tors!!

 

[blasterfreek30]

really no reason it shouldnt....nothing changed with it......more than likely its the POS tor

 

[2000blasternewb]

yeah were goin tocut it out of the harness tonight. the tors can make it to where theres no spark?

 

[blasterfreek30]

yeah were goin tocut it out of the harness tonight. the tors can make it to where theres no spark?

yea bro.....no spark, run like s*it......all kinds of probs

 

[2000blasternewb]

sh*t i didnt know it could cause no spark

 

[Juggaloclownz187]

Any problem you can name that electrical prob. has something to do with TORS if its still connected.... Should run good when you get that taken out of there! Good luck I:I

 

[smokeyfs200]

check to see if you put the ignition key in(stator plate over magneto), or in the right position, that could stop you from having and spark