Clutch problem?? Never seen this before??

[Blasterbuilder]

hi i have my motor apart (putting new top end in) and i noticed when i push the actuator(by hand) one side of the pressure plate moves farther away from the motor than the opposite side of the pressure plate

Ive looked arround and cant find help so i had to ask

Any suggestions?????

 

[Surfrjag]

its normal............

 

[Blasterbuilder]

its normal............

ok i should rephrase that, ive seen it before just not this extreme

 

[scotj77]

I replaced the adjustment rod, washer, nut, and pressure plate and it eliminated that problem. not very expensive either. where the adjustment rod attaches to the pressure plate get's worn after a lot of use

 

[Awk08]

do all the springs have the pink paint on them.... as in are they all stock ???
my first thoughts were someone mismatched a few with heavier ones,
which is possible to use just 3 if they are every other one

is it also possible a couple are weak ?????
i'd replace with all new 15% heavier ones