its been sitting for about 2 years and i just cleaned out my carb and put all fresh gas and oil in...it only runs for like 10 seconds after i spray some starter fluid in the air intake but thats it, then it dies...it wont idle on its own. any ideas on what else i can do?
Cant get my blaster to start
- Thread starter Papagoose24
- Start date
clean that carb again..
did you make sure to clean the pilot jet?
make sure gas is flowing from the tank float level is correct..
did you make sure to clean the pilot jet?
make sure gas is flowing from the tank float level is correct..
i got her running now, and it idles fine...but when i try to give it some gas it bogs out...what could that be
Jeff you ever do thats case? I just got my engine and its in peices as you can see in the pics/vids so ill be putting it together so lmk if you need some help
ya clogged pipe. dirty filter.change plug? mixing gas? 32:1. sounds too rich maybe the air mixture screw need adjusted, if this is all stock u should turn it all the way in bout 2 turns out
yea its all stock...the air filter seems fine and i put a new plug in....i just started it up before and messed around with the air screw a bit then i noticed its leaking a bunch of gas from that tube that hangs down in the back of the carb
how can i fix that can i just try and shake it without taking the whole carb off the bike again or do i need to take it apart again
that happened me once i changed the oil i was using and it was ok but now mine takes forever to start lol
you can try to tap on it with the back of a screw driver...
it may reseat properly if not you have to pull the carb and adjust the float..
it may reseat properly if not you have to pull the carb and adjust the float..
