Bushing

[aperich]

i have 99 blaster. front arm Bushing are bad. im looking at
http://cgi.ebay.com/ebaymotors/ws/e...tToStoreCat&refwidgettype=cross_promot_widget
for full kit and
http://cgi.ebay.com/ebaymotors/12-A...ryZ43974QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

i would like to get full kit but dont have money until next month. how can i tell if i need to replace my Pivot Pins. i would rather just replace my bushings for now but if i need to wate i will. later

 

[pittboss45]

The ones for $12.00 are shorter than the stock ones. We have ones that are $20 for the set, but the $12 set will work just fine. If you would like, we could get them to you by the weekend.

 

[SoloVRT61]

I have the 12 dollar set and just put them in..They dont seem any shorter to me, If they are..Its not by much thats for sure.. They are nice a tight now with the new bushings..I have not rode the quad yet but i expect it will be a bit more stable now..If you want to check if they are worn out, just shake your A-arm and check for play..If there is play replace them..If there is no play. leave them alone.

 

[aperich]

hay pittboss how would i go about getting them off you.

 

[BlasterUk]

My A-Arms have loads of play.. Do you onli need the rubber bushings replaced thats it? Simple fix? My back axel wobbles abit to!!

 

[BEAUXJANGLE]

the bushings in the a-arms are a type of plastic...poly/nylon somethin or another. I just replaced mine too cause they wuz jerkin around all over the place. If your axle is movin around, I'm pretty sure it's a bearing issue. It should be tight in the bearing carrier via bearings alone. You should probably replace the axle bearings along with the seals while you're in there.