i have a blaster that when i put it in gear, the bike stalls. Also the bike doesnt really idle too smooth when i give it gas it seems that the bike doesn't rev to its fullest pottential.
blaster stalls when put in gear. rough idle
- Thread starter juiceboxxx26
- Start date
i don't know too much about the jetting.it idles and revs. how do i go about setting air fuel mixture properly and is there any way of adjusting the carb???? there is only 1 adjustment screw on my bike.
if it is stock turn the air fuel screw all the way in and back it out 1.5 turn then adjust the idle
there is 1 screw that is metal and i use a screw driver to adjust it.... i have turned it all the way in and did that but it seems to be working better when i have the screw all the way in... what would cause that. how do i adjust the carb properly
pull in the clutch lever and tell us what it feels like. tight? easy to pull? i completely avoided this problem and rode it like this and guess what happened??? the clutch fried. so DONT AVOID IT!!!
i think it sounds like a clutch problem........check to see if the clutch arm lines up with the flat mark on the case
i wana give rep points to iifeatzz because the problem was a broken reed which i replaced with a borgota rewards card lol and now it rips asss