Axle swap

[Mr.Godin]

Been hearin banshee rear axles go right into a blaster. Iv got nothing to compare so im askin. Will the banshee rear axle fit into a blaster case. Is the race in the me place. Or do i bolt up the banshee case to the end of the swing arm. im not worries about the brakes i just want a wider axle.
Thanks

 

[yb200]

03+ blaster it will swap right in your carrier 02 and older blaster it will swap in your carrier but you will need a banshee brake hub or a blaster 03+ hub

 

[brandoz28]

search, this has been covered almost once a week

 

[Mr.Godin]

So the diameter of banshee and blaster axle is the same i just need a hub to act as a race? Iv got a 92

 

[yb200]

yes you just need the hub

 

[brandoz28]

i've got an extra brake hub....pm me if you want it

 

[Charles14]

hi, what is the hub exactly? can some1 post a pic to show me if not to much bothering?

is the thing in the middle or its the thing that holds the axle and holds the wheel? or its the thing where the chain is mounted?


thx a lot either answer or not


cheers

 

[brandoz28]

its the part that holds the brake rotor to the axle, they're different on the shee axle

 

[Charles14]

so u need to just change the break disk n the suport of it?

if i decide not to have a rear break can i use the banshee axle? wit no problems fit right up?


thx

 

[DUALSTROKE]

The banshee axle will go directly into any 88-06 blaster carrier.On the 03-06 you just need a shee axle and all else will swap directly over.On an 88-02 you need the shee axle and a shee brake hub and all other parts will swap directly over.The 03-06 blaster brake hub is the exact same part as the banshee brake hub.If you are going to use the stock brakes on the 88-02 with the shee axle there is a little modding to do.If you are converting to hydros then an 03-06 blaster carrier would work best,or you could make a bracket to convert it.There are so many options to go with hydros.Awk08 sells bolt on rear brake kits,you can p.m. him and may be the way to go for you.The shee carrier can work but it needs spacers to get it in line straight,I personally do not reccomend this method but to each his own.Lastly the brake hub is the piece that connects to the brake rotor.