Anyone interested in a good trade

[Zbskater400]

I'll make this as short as possible but I have practically a brand new keihin 34mm pj carburetor I bought new a couple months ago and rode with it twice and that's just too much for my blaster I only have a 3mm stroker and bored .60 over and fmf and toomey silencer with open lid but it's too much and I'm not looking to port it right now.. Id be willing to trade for a stock carb but if anyone is willing to roughly jet it to what Mods i have would be cool let me know thnk you

 

[jus_me]

What is your jetting now? Why do say it is to much ? Have you tried to plug chop yet?

 

[Zbskater400]

What is your jetting now? Why do say it is to much ? Have you tried to plug chop yet?

Ive been trying alot of different jetting and it's hard. I haven't touched it in a while I forget whats in it. It just runs bad

 

[Goldfox_32]

I got a stock carb with fresh rebuild does it require I diffrent boot to mount to the reeds ? If I were to trade you ? I got a 300 and a 320 jet for it aswell

 

[Zbskater400]

I got a stock carb with fresh rebuild does it require I diffrent boot to mount to the reeds ? If I were to trade you ? I got a 300 and a 320 jet for it aswell

You can dremel the stock boot for it to work or buy a 34mm boot I dremeled mine out. I just wanna ride lol

 

[MURPH]

A #6 slide and a cel needle for lower elevations or dgh needle for higher elevations is a must for bigger
Kiehn carbs to work in the blaster.

 

[Goldfox_32]

You can dremel the stock boot for it to work or buy a 34mm boot I dremeled mine out. I just wanna ride lol

Well let me know if u Wana trade pm me I'm sure I can fiqure out something to do with it.

 

[2strokerdie]

Hey bud I know I'm a little late but are you all set with a carb?

 

[Awk08]

Hey bud I know I'm a little late but are you all set with a carb?

the trade above did take place.

 

[2strokerdie]

Thanks for lettin me know awk, btw merry Christmas and don't drink to much of the high test egg nog haha!!