Alright in my searching I see u have to drill out the hole on the banshee spindles to fit them to the blaster. But I see it is the non recommended way. So my ? Is what is everyone's fear in doing this just that u will not have the taper to tightly hold the ball joint or something? And if u have done it how is it working for u
? About banshee front hydros
- Thread starter Shawn88
- Start date
like $150, or $125 with an exhcange of your existing spindles
available here, half way down, far right column..........
OEM Yamaha Blaster Parts
Alright cool man thank you. Ill prob pick up this banshee stuff then grab those spindals cause althought I could do the machine work on the banshee spindals I would prefer to go the safer route
