Recent content by sikkendistrbed1

Apparently after getting the ball bearing back in i misaligned the pressure plate now thats good but cracked the clutch cover trying to take out the oil injection. So still not riding but part on the way so it will be soon thanks agian for all the help

I give up. I cant figure it out. Im kinda busy right now but i should have some time in the next couple weeks. Im gunna take it apart and start from scratch checking everything to what the manuel says. If anybody has any tricks or tips please feel free to comment. I could use all the help i can...

I am downloading the manual posted by awk08 Im sure it will help with many problems. I dont have much experiance working on quads so any help i can get is greatly appreciated.

I took the clutch cover off pulled the pressure plate greased the ball dropped it in the hole put pressure plate back on. Ive tried adjusting the screw in the middle of the pressure plate and the cable at the handle but either its real loose and dont work or its feels like its binding up and...

okay thanks again, yes the cable holder is back on the jug.

Just thought about it all i rebuilt was the top end. I didnt even open the clutch side but the pin poped out when i flipped the motor so i don<t know where the ball came from. Does it go where the pin does? If so on the clutch side or crank side?

cool thanks i should be able to get back to it in the next couple days. Ill let you know how it went. Thanks agian

:-/I just rebuilt my motor mounted it ready to go but when i hooked up the clutch cable it pulls real easy if i put in gear and pull clutch it dont move. I have heard it could be a ball that goes to the push pin for the clutch. I did find a small steel ball on my work bench. Could this be it...