Recent content by randysblaster00

the Toomey was designed for the original cc size that is why I said I thought it could be that the needle is on the second highest setting and I do not believe it is leaking because I only touched the top end and the bottom was not leaking before if it is leaking it will be leaking in the intake...

is there any way to make this carb work right for the time being or am I screwed

haha my only option on the budget I was on so I got it and plus I was recommended a round slide

its a round slide carb I looked up pj34mm and it was a flat slide my carb is the pe34mm round slide

150 mains and 52 pilot jet

numbers on slide are 2GE 3.0 numbers on needle are D105 haven't gotten to the jets yet

was thinking the Toomey exhaust may have too much back pressure

doesn't leak has good compression not sure exact psi going to check jets now but I have a 52 pilot

I have a 2000 blaster I just put a vito's 240 kit in it after market parts I have installed are Toomey b1 full exhaust vitos 2 stage reeds and a 34mm keihn carb off a cr250 bike the blaster doesn't seem to have any bottom end power if I hit the gas to roost or just play around it falls on its...