Recent content by psebowdoc

ok i took it back apart and the oring was bad on the needle seat. i replaced it and got it back in with no problems this time. i also adjusted the floats but it is still doing the same thing. i looked at a diagram of the carb today and i am missing the main jet washer. would this make it do what...

thanks scott i will take it back out and make sure there is nothing in it. awk 08 i also had a concern with the part you are talking about. i put the jet in but it kept sliding up inside carburatoer. that valve inside has a slit in it and there is a (tit) on the inside that you line up and slide...

let me just put it this way there is a closed end that has the little hole in it and then the other end is opened up. the way i put it in is the closed end with a small hole up and the opened end down so the needle will go up in it.

ok so time for the dumb guestion. when i put the needle seat in i had a hard time getting it in the whole. i had to pound it in. is this normal. also the needle fits up inside the seat right? maybe i don't have it all the way down in there or something. is this really the only thing that...

i am new to this site. i have a yamaha blaster that i just rebuilt the carb on. now that i rebuilt it, it is getting way to much gas. all you have to do is turn the gas on and the key over and gas comes flowing out the overflows. it has all new jets and needles. the float is also new and in the...