Recent content by Mr.Aaron

  1. M

    WTB Intake Boot (28mm mikuni)

    Ahh I didn't think of that....Another issue I was having that it was blocking I believe the "air jet" not really sure if that's the correct term. It's the small gold jet on the very bottom.
  2. M

    WTB Intake Boot (28mm mikuni)

    Looking for an intake that will fit a 28mm FS mikuni carb. The stock one is a little to small. Also looking for a jetkit for this carb if you have one laying around.
  3. M

    28mm Carb question

    It's not that the boots to small, the boots to big for the carb. I tried to clamp it down all the way but the carb can just slide right back out. So the boots not grabbing the carb and holding in place.
  4. M

    28mm Carb question

    I picked up a 28mm Mikuni FS carb and turns out the stock intake boot is a little to big to fit the carb. I was wondering for those that run this carb what you did to make it fit? Also where can I find a jets or a jet kit for this carb? Appreciate all the help guys!
  5. M

    Pre mix or oil injection?

    I just have the motor, was wondering how I could tell by just looking at the motor.
  6. M

    Pre mix or oil injection?

    Hey Guy's I was wondering how can I tell by looking at my motor if it uses pre-mix or has oil injection? What are the benefits from going with pre mix?
  7. M

    WTB Carb

    Anybody have a flat side mikuni carb laying around?I:I Or possibly a stocker?
  8. M

    Quick Question

    I am looking at picking up a 2001 Blaster motor and was wondering is the crank balanced on these motors(i.e counter balancers)?
  9. M

    Complete Motor

    Hey Guy's Was wondering if anybody has or is considering parting out one of there blasters. I am looking for a complete motor with a wiring harness and pipe, if you have any of the following let me knowI:I
See more
Top Bottom
Back