Recent content by John Uschan

Now when I pull in my clutch lever the whole clutch assembly moves. It's does not go back to normal position when clutch is released. So when I pull clutch instead of the pressure plate moving the whole assembly moves. Any ideas?

I took them all out and put them back in when I rebuilt the engine. I'm starting to think I may not have the clutch adjusted right.

The gentleman I purchased it from said it has sat for a while. I have had case split because it was leaking. I have fresh oil in it now and all back together.

I recently had my cylinder bored to .010". I purchased a new wiseco piston kit. I rebuilt my carb and installed oil block kit and tors delete. Upon assembly of engine I install a new fixed stator. Quad started on third kick while being choked. After letting I'd run for a good while I pulled in...

Hello everyone, Does any one know the torque pattern for the engine case?