Recent content by gavicc

jug is good. Just got to clean out the case.

Sweet. Now I'm on track. Now.....where is a good place to get one or a kit of jets to work with that is a decent price? Maybe a carb kit with them. Thanks

I took the carb apart and got some numbers. Jet - 250 Needle - 5J22 I couldnt tell what ring the clip was on the needle but it looked like the second one as it kind of fell off as I was taking it out. What one should it be on? I measured the ID of both sides of the carb. One was 23mm and...

Could running the .080 over bore, with an FMF gold series pipe on a stock carb with a stock needle and jet be what caused the engine to run too lean and melt the piston? I have no idea what the guy who previously owned has done to it other that what I have stated. I'm lucky I measured the bore...

I dont know what size reeds or jets it has. It has a FMF Gold Series pipe and silencer. Thanks

It looks like a stock Mikuni. Will a stock carb work well with the .080 bore?

I just bought a 00' blaster. I am replacing the piston because it melted a hole through the middle of it. I'm guessing its running too lean. I am going to refresh the top end with a piston kit and gaskets. It has a .080 bore. What do I need to check or adjust in the carb to make sure it is set...

I bought a 2000 Blaster from some d bag and it stopped running 20 min after my first actual cruise on it. I tried to start it up and it sounds funny like the piston isn't moving. I'm guessing its the connecting rod. If so, what will cause the connecting rod to break? Bearings? I don't want to...