Recent content by FasterBlaster03

I am on the look out for a yz250 engine that will fit on the 03 yz250 frame. It just needs to be the whole bottom end and maybe could have the jug. This is for another yz250 I am building frame up!!

Bike started 3rd kick after a good carb prime. I guess you can't test shift it on a bench unless u got the hands of hurcules . Bike has lots of torque!! Might up a size in countershaft sprocket to help longevity speed. May reject to 290 or 300. Have a 280 in her and header gets way to hot to...

Ok thanks will split cases when I get home from work and check for debris in the blind hole. Also last time I split cases the bearing comes off with shift drum. Witch seems like a normally happens with blasters

Also I did not use assembly grease for these parts only for new tranny bearings I installed

Yes tranny is free and I only had one washer that's on the clutch side casing and that behind the bearing. I'm weirded out over this because after I tighten case bolts the shift drum locks up but has slight movement but very hesitant. After I loosen the case bolts, the shift drum begins to...

I got the cases back together and the shift drum locks up when I tighten the case bolts but when I loosen the case screws again the drum turns freely. Is this normal? The shift drum bearing has a washer behind it and that's all that been installed. Is there supposed to be a washer to go on the...

Yessir the anticipation on getting the stuff is killing me right nowo_O.

Forgot to mention I got koyo crank bearings and I got paper gasket to cut my Reed gaskets. Already have a clutch gasket on standby:)

Ended up getting Vito's 3 mil stroker crank with full Vito's seal kit, hot rods tranny and counterbalancer bearings, head gasket and that's it.

Everything is ordered! Can't wait for the crank to get here!

Thanks

Can I get the front spindle assembly's?

Hey I believe I've bought from your ebay account before I got a high compression head. I was wondering if you had the front spindle assembly's off of an 03-06 blaster I'm trying to swap over to hydro brakes on my 01 blaster

Hey I'm located in hillsborough 27278 nc I'll take both of the front spindle assembly's if you still got them

Got the whole spindle assembly? I'll take both of those