Recent content by BlackNWhite2001

will take cash offers. delivery within a certain radius... let me know

I'm in fishkill NY here's my post: "Runs great. Mostly Stock. Vito's oil block off installed. Tail light, head light removed. All parts taken off including oil injection parts included. Razr MX Rear tires on the bike. Comes with Shredder rears and an extra set of front tires. General wear and...

Runs great. Mostly Stock. Vito's oil block off installed. Tail light, head light removed. All parts taken off including oil injection parts included. Razr MX Rear tires on the bike. Comes with Shredder rears and an extra set of front tires. General wear and tear but still a great bike. Located...

hey quick question. I recently bought some Reddy Racing Pre-Oiled racing filters for my blaster. When i screwed the air filter in place on the housing, the screw goes right through the hole in the top of the filter and doesnt bring the filter with it, leaving the hole in the top open. Is this a...

do you have the kickstart assembly?

do you still have the kickstart assembly? how much?

do you have the kickstart asembly? how much

do you have the kickstart assembly?

yeah i dont have a volt or multimeter readily available and i'm pretty sure I won't be going out to buy one haha. i was just hoping someone could tell me instead going to get a light bulb to test it with haha. They do design normally open circuit and normally closed circuit kill switches, thats...

do you have the kick start assembly? how much?

I have two questions: 1. I took of the key to my 2001 blaster. From looking at the wiring diagrams it seems that leaving an open circuit will allow for the ATV to start, correct? By just electrical taping the wires so they didnt touch anything, it should start fine? 2. My friend gave me a...

yeah i tried it again and same thing happened. It seems that the spring doesnt sit correctly when the end of the spring is positioned correctly. When it is in the correct position, the coiled part of the spring towards the inside of the kick start assembly inside of the clutch case sits at an...

the c ring i mean is number 3 on the diagram and when i put the spring in i had to stretch i backwards about an inch to get it into the hole. i'll try again and see what happens

ok, i did that. i reseated the spring and set it so when i put the clutch cover back on the spring end was in the hole. when i tested the kick starter it didnt spring back and the c ring on the kick starter gear popped off. i dont know why. the spring was back where it was supposed to be..

Is the hole it's supposed to be sitting in on the engine itself? If it is, I think I see it, I just want to be sure