Recent content by Bighoss860

Found the intake boot and clamp were no good, as well as the left side crank seal as I did a leak down test will advise after new parts are installed thanks for the help!

Sounds good, I’ll do the seals is there anything else I should look for /replace once I have it apart?

Is there an easy way to tell just from looks if the seal is bad?

Just sprayed some gas oil mix behind flywheel and motor reved higher…..

Hey all, have a 89 blaster that has been sitting outside for years. Firstly it wouldn’t run so did all the basics compression good at 120psi, rebuilt the carb installed all new gaskets on the top end new reeds air filter, cleaned the gas tank with fresh 93 gas new stator and fly wheel as the...