Recent content by bianca_blaster98

are you sure your air srew is adjusted properly ?? the air screw is on the choke side directly on your carb ... to adjust it right you need to tighten the screw and then unsrew it of a turn and a half... you could check to make sure it's adjusted correctly first... because I had that high...

and if my clutch doesn't disengage completly?? when I hold the clutch and engage the 1st( just engage it while holding the clutch) my idle slows down a lot...it seems like something is rubbing... can i just adjust something or do I need to replace the whole clutch ?? and can I do it myself ...

YES a banshee axle can fit on a pre 03 blaster... I just did it with mine... I have a 98 blaster and I've installed an 03 Banshee axle (with the bashee hub too)... I just had to add 3 washers to each disc brake bolt (the 4 bolts) so that the disc brake could align perfectly with the brake...

I have a problem with the setting of my idle... when my blaster is cold it runs too low and when it's hot it runs too high... I've tried to set it right with that little screw on my carb but it only gets worse... does anybody has an idea of what it could be ?? also my choke(I'm talking about...

just wanted to be sure... ok so just to be sure... to put a banshee 03 original axle on my 98 blaster, I just need to add a spacer ?? can I keep my original brake hub or do I have to put on the banshee brake hub with no spacer?? because I've cheked on many forums and nobody never really...