Recent content by BallzDeep38

ok guys it took me ALOT longer to get back to this project then I expected. here is where I am at now. I disassembled the engine and found 2 Ball bearings in it. What was happening was with the second ball bearing in the clutch was hitting the cover and not allowing the clutch to disengage when...

ok thanks. any tips for getting the ball out of there, other than taking out hte pressure plate and rod and tipping the bike over?

Ok here is a little more info. the bike idles and revs up just fine in neutral. if i try to start it in gear (with the clutch pulled in) it pushes the bike forward. so i also think my problem is with the clutch. I remember putting the little ball in. I did however have apart for a few days...

I recently bought a 99 blaster with a bad bottom end. i replaced the bottom end with a used one. after rebuilding the top end and carb i get it running. now it idles fine, but when i shift out of neutral into 1st it pops forward and dies. when i swapped the clutch over the plates didnt look bad...