Recent content by 1991dt200r

Hi, Thank you for the measurements. That info should be a good start. (Better than what I had i.e no measurement at all) It is hard to gather information about the Blaster in Australia, because they are as rare as hen's teeth. Great that you guys would help me out. Maybe I will be able to...

hi there, Do you know if it was the DT200L or DT200R model? They are different motors. L model is piston port, R model case reed induction. i.e no port windows in the piston I believe that most guys over there that have done the engine conversion in their Blasters more than likely used the L...

Hi all, I am looking for the measurements for a Blaster Crank. A diagram showing specs/measurements would be great if anyone has one. Or if someone feels like getting out the micrometer......... Thanks guys, Jamie- Australia

hi guys, I am new to the forum(met some of you already in the introductions section, thanks for your replies). Has anyone used a Blaster stroker crankshaft kit in the DT200R engine? If yes will it work without any other mods(assuming a spacer plate is used), or are there porting issues, or...

hey guys Thank you for your welcoming me to the forum. I will post my question elsewhere on the forum, in hope of some info. Any suggestions as to the best place to post my questions? Thank you all once again- James, Australia

Hi people my name is James I live in Australia. I am rebuilding a 1991 dt200r(I know this is a Blaster Forum, but wait my questions will be relevant) I was wondering if anyone had swapped a dt200r engine into their Blaster, and used the Blaster +3mm stroker crankshaft kit? Does anyone know if...