I welded 3 nuts together to make the coupler

put some nasty welds all around that and and get it on the bench grinder to round it out and boom looks factory

yeah ive smoothed it out and painted since then

i always heard of them using zip ties

this adapter was used to take up the slack when i put the tm cable on the stock blaster thumb throttle. i took a bolt that would thread into the throttle and chopped the head off , drilled out the center then welded 3 nuts together.I then chopped off the throttle stop on the underside of the throttle and marked 1/4,1/2, 3/4 and full throttle so i could tune each level on the carb.